If none of these materials is available to you you can always elect water quality to soak rags or towels in hot water and wrap them around the frozen pipe. This will probably take longer than any of the methods previously mentioned.
Be cautious. If you've just become aware of a problem with water line repair in your home, there are a few steps you should take. First, if there's a lot of water (such as from flooding), you should turn off your electricity to avoid electrocution. Also, don't use your regular household appliances (such as a vacuum cleaner) to remove water. If the water is contaminated (such as from a sewage line), you and your family should leave the home so that you don't get sick. Finally, if the water is from a leak, try to locate the leak's source and turn off the water to prevent further damage.
One other common design that is considered "washerless" was made famous by Delta and copied by several other makers. It uses little "cup" seals that fit over springs recessed in the back of the valve body. The springs press these "seals" against the cartridge and regulate the flow through little tapered openings in the cartridge. If you have one of these and it's dripping, changing these springs and seals will usually correct it. Here's a tip. Once you have the cartridge out of the way, insert a phillips screwdriver into the seal and pop both the seal and spring out. Stick the new ones on the end of the screwdriver to help guide them into place. This is especially helpful if you don't have long slender fingers.
Working on the gas lines is also a complex job that only a licensed plumber can handle because it is very dangerous. Small leaks can't always be detected by odor alone, but a licensed professional has the proper equipment that's needed to ensure that you don't have any leaks in the line.
The first step in the replacement project is to turn off the water line repair to the toilet and flush any water that may be in the tank. If you forget this step, you will have a giant mess to clean up! You should now disconnect that water line.
When doing the install on a water heater, keep an eye out for unconnected pipes. A commonly missed pipe is the one that leads out from the area for drainage. It is probably a recirculation pipe; that helps your water remain heated without wasting too much water.
The next huge thing is to prevent and kill mold that has already started growing. Mold is the most dangerous thing when an area floods. Mold can turn deadly within a extended period of time. Use mold killing agents like Killz and other products on the the market. Be extremely thorough with this process. If the water flooded above the dry wall line, you MUST remove the dry wall to make sure you can replace insulation and dry wall which mold naturally is attracted to. Painting a Killz primer on the concrete is a great idea before installing new carpet and drywall. This will ensure that you have prevented future mold growth and will also ensure the safety of your family.